+- iomixer forums (https://iomixer.com/forums)
+-- Forum: General (https://iomixer.com/forums/forumdisplay.php?fid=1)
+--- Forum: General questions about usage (https://iomixer.com/forums/forumdisplay.php?fid=2)
+--- Thread: Supporting Remora? (/showthread.php?tid=1)
Supporting Remora? - mdroberts1243 - 10-31-2024
Hi,
Is Remora ( or equivalent ) supported for LinuxCNC?
RE: Supporting Remora? - mdroberts1243 - 10-31-2024
(10-31-2024, 05:08 PM)mdroberts1243 Wrote: Hi,
Is Remora ( or equivalent ) supported for LinuxCNC?
Sorry, I think I confused the project with WeenyPRU. I thought they were related somehow, but are quite separate pieces of hardware!
RE: Supporting Remora? - iforce2d - 11-01-2024
Hi mdroberts
Yeah iomixer is a different project. The concept for weenyPRU was based on Remora and is quite similar in many ways, there is even a little source code in common. It is specifically intended for LinuxCNC, but there is no effort made for ongoing compatibility with Remora. Currently the best place to discuss weenyPRU is probably the github issues page. https://github.com/iforce2d/weenyPRU